Toshiba D-VR3SU Service Manual page 85

5-4-25 Hook Capstan, Belt Pulley Removal
1) Remove the Hook Capstan Πafter realeasing
Hook in the direction arrow as shown in detail
drawing.
2) Remove the Belt Pulley ´.
Note : Take extreme care not to get grease on Belt
Pulley ´ at assembling or reassembling.
´ BELT PULLEY
ΠHOOK CAPSTAN
Fig. 5-38 Hook Capstan, Belt Pulley Removal
5-4-26 Motor Capstan Ass'y Removal
1) Remove the Damper Capstan Πin the direction
of arrow.
2) Remove the 3 Screws ´.
3) Remove the Motor Capstan Ass'y ˇ.
Assembly :
1) Match the 3 holes of Motor Capstan Ass'y ˇ to the
3 holes of Main Base. Be careful not to drop or
knock the Motor Capstan Ass'y ˇ.
2) Tighten the 3 Screws ´ in the direction of arrow
as shown detail drawing.
3) Assemble the Damper Capstan Œ.
HOOK
Note : After tightening screws, check if there is gap
between the head of screws and the top side of Main
Base. There should have no gap between the head of
screws and the top side of Main Base.
After reinstalling, adjusting the tape transport
system again.
Π3 SCREWS
Fig. 5-39 Motor Capstan Ass'y Removal
Disassembly and Reassembly
C
A
B
´ MOTOR CAPSTAN ASS'Y
5-19