100--120/200--240-Volt Configurations - Kohler 6EKOD Installation Manual

L0 (Neutral)
Ground
Load
Side
Line
Side
4 3 2 1
Figure 8-2 100--120-Volt, 3-Wire Configuration
8.2.2 100- -120/200- -240-Volt
Configurations
The 100--120/200--240-volt configuration does not use
a jumper lead. If the unit was originally wired for straight
100--120 volt, 3-wire, remove the jumper lead (see
Figure 8-2 for location).
breaker. Application of two single-pole circuit breakers
does not conform to NEC requirements for supplying a
200--240-volt load, even
mechanically attached together. Leads L1 and L2 are
for different phases; never connect them together.
L0 (Neutral)
Ground
Load
Side
Line
Side
4 3 2 1
Stator Leads
60 Hz
L0--L1 100--120 Volt
L0--L2 100--120 Volt
Figure 8-3 100--120-Volt, 2-Wire Configuration
TP-6773 5/12a
L0
GRD.
L1
L2
Two-Pole
Circuit
Breaker
Jumper
lead
Select a two-pole circuit
if the breakers are
L0
GRD.
L1
Single-Pole
Circuit
Breaker
50 Hz
100--120 Volt
100--120 Volt
L0 (Neutral)
Ground
Load
Side
Line
Side
4 3 2 1
Stator Leads
60 Hz
L0--L1 100--120 Volt
L0--L2 100--120 Volt
L1--L2 200--240 Volt
Figure 8-4 100--120/200--240-Volt, 3-Wire
Configuration
8.2.3 200- -240-Volt Configurations
The 200--240-volt configuration does not use a jumper
lead. If the unit was originally wired for straight 100--120
volt, 3-wire, remove the jumper lead (see Figure 8-2 for
location). See Figure 8-5 for EOZD/EFOZD models
equipped with the ADC 2100.
L0 (Neutral)
Ground
Load
Side
Line
Side
4 1 3 2
Stator Leads
60 Hz
L0--L1 200-240 Volt 200--220--240 Volt
Figure 8-5 200--220--240-Volt, 2-Wire Configuration
for Models with ADC IId
L0
GRD.
L1
L2
Factory
Two-Pole
Circuit
Breaker
100- -120/200- -240-Volt,
3-Wire
50 Hz
100--120 Volt
100--120 Volt
200--240 Volt
L0
GRD.
L1
Single-Pole
Circuit
Breaker
Tape to insulate
from ground
200- -220- -240 Volt
2 Wire
50 Hz
Section 8 Reconnection 47