Cleaning Instructions; Indoor Unit; Front Panel - Panasonic CS-RE18PKR Operating Instructions Manual

Cleaning instructions

To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. Dirty unit may cause malfunction
and you may see error code "H99". Please
consult authorised dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fi n, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap ( pH 7) or neutral household
detergent.
• Do not use water hotter than 40 °C.

Indoor unit

Wipe the unit gently with a soft,
dry cloth.

Front panel

Wash gently and dry.
Remove the front panel
2 Pull out
1 Raise
Close it securely
Press both ends of
3
the front panel
2
Close down
4
Press at center of the front panel
F569362_YA0413-0_EN.indd 9 F569362_YA0413-0_EN.indd 9
Indoor unit
Air fi lters
Every 2 weeks
• Wash/rinse the fi lters gently
with water to avoid damage to
the fi lter surface.
• Dry the fi lters thoroughly under shade, away
from fi re or direct sunlight.
• Replace any damaged fi lters.
Remove air fi lter
Anti-bacterial fi lter
• Clean the fi lter whenever necessary.
• Wash/rinse the fi lter gently with water to avoid
1 Insert at damage to the fi lter.
both sides • Dry the fi lter thoroughly under the shade, away
from fi re or direct sunlight.
• Replace the fi lter every 10 years or replace any
damaged fi lter. Part no.: CZ-SA22P
For seasonal inspection after extended non-use
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select COOL/HEAT
For extended non-use
• Activate HEAT mode for 2~3 hours to remove
• Turn off the power supply and unplug.
• Remove the remote control batteries.
Front panel Aluminium fi n
Air fi lters
Attach air fi lter
Insert into the unit
Anti-bacterial fi lter.
operation. After 15 minutes of operation, it is normal to
have the following temperature difference between air
inlet and air outlet vents:
COOL: ≥ 8 °C HEAT: ≥ 14 °C
moisture left in the internal parts thoroughly to prevent
mould growth.
Anti-bacterial fi lter
9
6/14/2013 10:09:49 AM 6/14/2013 10:09:49 AM