Deleting Phrase - Boss RC-3 Owner's Manual

Loop station
Hide thumbs Also See for RC-3:
Table of Contents

Advertisement

While the phrase is being saved, the number in the display and
the PLAY indicator will blink rapidly.
NOTE
* Never turn off the power while the PLAY indicator is
blinking rapidly. This may cause all saved data to be
lost.
* Please be aware that the contents of memory can
be irretrievably lost as a result of a malfunction or
improper operation of the unit. You should back up
important data as described in "Backing up to your
computer" (p. 14).
* All due care is taken during repairs to avoid the loss
of data. However, in certain cases, such as when there
is damage to the memory, it may not be possible to
restore the data.
* Unfortunately, it may be impossible to restore the
contents of data that was stored in the unit's memory
once it has been lost. Roland Corporation assumes no
liability concerning such loss of data.
Deleting a Phrase
* This device contains demo phrases (90–99). Once you delete
these, they cannot be recovered. Please back them up as
described in "Backing up to your computer" (p. 14).
1. Use the [ ] / [ ] buttons to select the phrase
memory that you want to delete.
2. While playback is stopped, hold down the [WRITE]
button for at least two seconds.
The display will indicate "
dL
* At this point, you can't change the phrase memory number
that will be deleted.
3. Press the [WRITE] button to delete the phrase.
If you decide not to delete the phrase, press the [TAP TEMPO]
button, the [RHYTHM ON/OFF] button, or the pedal.
While the phrase is being deleted, the number in the display
and the PLAY indicator will blink rapidly.
* Never turn off the power while the PLAY indicator is blinking
rapidly. This may cause all saved data to be lost.
Basic Operation
. "
9

Advertisement

Table of Contents
loading

Table of Contents