Table of Contents
Advertisement
Troubleshooting
Problem
Recording does not end
immediately when you press
the pedal
Recording started
immediately even though
Auto recording mode is
selected
Cannot change the playback
tempo
Error Message List
Display
Meaning
bt
The battery has run low.
FL
Memory is full.
UF
This WAV file is unplayable.
EF
Further overdubbing is not possible.
Er
Internal memory must be formatted.
dN
The RC-3 has malfunctioned.
20
Action
If rhythm is on, or if you recorded a phrase that is shorter than the minimum recording time (approximately
1.5 seconds), the length of the phrase is adjusted automatically; this may mean that recording does not end
immediately when you press the pedal.
If due to distortion or other causes there is a significant amount of noise, that noise may be enough to
trigger the beginning of recording. Reduce the noise, for example by lowering the distortion level.
You cannot change the playback tempo in the following situations.
• If the phrase has not been saved.
• While phrases are being switched (PLAY indicator blinking rapidly).
• When you attempt to set the tempo for a phrase that is looped over an interval shorter than the
minimum recording time (approximately 1.5 seconds).
Action
Replace the battery.
Delete unneeded phrases.
Check the format of the WAV file.
Re-save the phrase.
Format the RC-3's internal memory.
Contact your dealer.
Page
p. 22
p. 9
p. 14
p. 8
p. 19
Hide quick links:
Advertisement
Table of Contents
