46
11. Room monitor
You can use your C5010A handset to monitor the sounds in another room.
If the sounds reach a certain level the handset will automatically dial out to
a pre-set external number or to another handset. When the Room Monitor
is set to On, the handset will display Room Monitor On and only the
microphone will be active to monitor the sound levels in the room. Both the
speaker and receiver will be set to Off and the handset will not ring if there is
an incoming call.
11.1
To switch Room Monitor On
1. Press Menu, scroll
Select. Mode will be highlighted.
2. Press Select, scroll
seconds.
3.
The handset returns to idle screen and display as Room Monitor
off Room Monitor press Off.
4. Press
to return to standby.
11.2
To change the monitor level
The monitor level can be set to High or Low, the default setting is "Low" .
To increase the sensitivity of the Room Monitor:
1. Press Menu, scroll
Select. Mode will be highlighted.
2. Scroll to Level, press Select and scroll or to select Low or High setting.
3. Press
to return to standby.
11.3
To set the dial out number
1. Press Menu, scroll
Select. Mode will be highlighted.
2. Scroll to Call To and press Select.
3. Use the or key to select External or Internal.
External
1.
Press Select and Enter
2. Enter the number and press Save. Saved will be displayed. When Room
Monitor is switched on and the sound level reaches a certain level the
number will be automatically dialled.
Room monitior
to Extra then press Select. Room
to On then press Select. Set to
to Extra then press Select. Room
to Extra then press Select. Room
Number: prompt will be displayed.
Monitor is highlighted. Press
ON is displayed for 2
On. T o switch
Monitor is highlighted. Press
Monitor is highlighted. Press