Kenwood CK 405 G Instructions For Use - Installation Advice page 13

IGNITION OF THE OVEN BURNER
ATTENTION: Never turn the control
knob before opening the oven door.
To light the oven burner operate as follows:
1. Open the oven door to the full extent.
WARNING: Risk of explosion! The


oven door must be open during this
operation.
2. Lightly press and turn the thermostat
knob anti-clockwise (fig. 4.4) to max
position
knob firmly until the burner lights.
Never continue this operation for


more than 15 seconds. If the burner
has still not ignited, wait for about
1 minute prior to repeating the
ignition.

In case of mains failure, press the
knob firmly and immediately approach
a lighted match or taper to the opening
"A" (fig. 4.3).
3. Wait a few seconds after the burner
lighting before releasing the knob
(time of priming of the valve).
4. Close the oven door slowly and adjust
the burner according to the power
required.
If the flame extinguishes for any reason,
the safety valve will automatically shut off
the gas supply to the burner.
To re-light the burner, first turn the oven
control knob to the off position
for at least 1 minute and then repeat the
lighting procedure.
OVEN COOKING
Before introducing the food, preheat the
oven to the desired temperature.
For a correct preheating operation, it is
advisable to remove the tray from the oven
and introduce it together with the food,
when the oven has reached the desired
temperature.
Check the cooking time and turn off the
oven 5 minutes before the theoretical time
to recuperate the stored heat.
(fig. 4.1). Press the
0
, wait
A
Fig. 4.3
Fig. 4.4
13