Lexmark T640 User Manual page 13

Lexmark users guide printer t640, t642, t644
Hide thumbs Also See for T640:
Table of Contents

Advertisement

Before you can print, you must establish communication between the printer and computer. To do this:
1
Set serial parameters in the printer.
2
Install a printer driver on the attached computer.
3
Match the serial settings in the COM port.
Setting parameters in the printer
1
Press
on the operator panel.
2
Press
until
Note: For information about serial menus and messages, see the publications CD that shipped with the
printer.
3
Press
until
The printer returns to Ready.
4
Press
.
5
Press
until
6
Press
until
(x) is the number of the serial port.
7
Press
until
press
.
8
Press
until
then press
.
Note the following restrictions:
Maximum baud rate supported is 115,200.
Data Bits must be set to 7 or 8.
Parity must be set to Even, Odd, or None.
Stop Bits must be set to 2.
Flow Control recommended protocol setting is Xon/Xoff.
9
Press
.
The printer returns to Serial or Serial x.
10
Print a Menu Settings page, and verify the serial parameters are correct.
Note: Keep this page for later use.
a
Press
on the operator panel.
b
Press
until
c
Press
until
d
Look under the Standard Serial (or Serial Option X if a serial interface card is installed) heading to find the
serial parameters.
Installing drivers for local printing
Reports appears, and then press
Menu Settings Page appears, and then press
Network/Ports appears, and then press
Serial Standard or
<Parameter> appears (where <Parameter> is the parameter required for a change), and then
<Setting> appears (where <Setting> is the setting required for a change), and
Reports appears, and then press
Menu Settings Page appears, and then press
.
.
.
Serial Option X appears, and then press
.
Windows
13
.
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents