Advertisement
DISASSEMBLING PROCEDURES
● Disassembling procedures
In reverse of assembling procedures.
● Assembling procedures
1.Hook M076 to M070, and screw the five screws(Ⓙ).
2.Pull out the slide part of the S3-CHASSIS, and pass the arm through
to the hole of the S3-PANEL-SUB.<Step1~3>
3.Screw the three screws(Ⓐ).
M076: ASSY-PCB-PANEL
Ⓙ x 5
No.
Screw
Tighten torque(N・ｍ）
Ⓐ
M3X6
0.7 +0.2/-0.1
Ⓙ
2X4
0.12 +0.01/-0.01
(3)Push the front of panel to
Latch M076 to the hooks.
connector mating. <Step3>
Ⓐ x 3
S3-PANEL-SUB
(2)After passed the one arm, pass another
arm with bending it internally. <Step2>
Do not give scratch to panel by arms.
S3-PANEL-SUB
Arm
Slide chassis
<Step2> After passed the arm of one
<Step1> Pass the tip of slide chassis
through to panel by each.
side, pass the another side of arms.
M070: ASSY-PANEL-SUB
Remove the arm protector.
(4) Push the square holes at side(two places) and
downside(three places), till the hooks set.<Step3>
4
Copyright (C) Mitsubishi Electric Corporation.
NR-261UM-07LAN5
Arm
<Step3> Push the front of panel.
S3-CHASSIS
Remove the arm protector.
(1)After pull out the slide chassis till it stops, pass the
tip through to panel each one side. <Step1>
Your company internal use only.
Advertisement
