Printing A Network Setup Page; Wireless Configuration Does Not Continue After The Usb Cable Is Attached - Lexmark 4600 Series User Manual

•
The computer and printer are both connected to the same wireless network.

Printing a network setup page

A network setup page lists the configuration settings of the printer, including the IP address and MAC address of the
printer. You can print a network setup page only if your printer has an internal wireless print server.
1
Load plain paper.
2
From the printer control panel, press
3
Press the arrow buttons until Network Setup appears, and then press
Print Setup Page appears on the display.
4
Press .
5
Press again.
The network setup page prints.
Wireless configuration does not continue after the USB cable is
attached
Check the USB cable
If the configuration software does not allow you to continue configuring your printer wirelessly after you attach the
USB cable, there may be a problem with the cable. Try one or more of the following:
•
Make sure that the USB cable is not damaged. If there is any visible damage to the USB cable, try using a new one.
•
Attach the cable directly to the computer and the printer. Hubs, switch boxes, and docking stations can sometimes
interfere with the USB connection.
•
Make sure the USB cable is correctly attached.
1
Attach the large, rectangular connector to any USB port on your computer. USB ports may be on the front or
the back of the computer, and may be horizontal or vertical.
.
112
.