Verity Medical NeuroTrac Sports Operator's Manual page 8

Setting up the Customised Programme PC1, PC2 or PC3
Remove the battery cover where you will see two buttons SET and ESC, these
buttons are used to set up a customised programme.
First press the ESC button to return to the home screen
1. Press the SET button and the Hz symbol will flash on/off, then press
the + or – button on the front panel to adjust the Pulse Rate.
2. Press the SET button again and the µS symbol will flash on/off, then
press the + or – button to adjust the Pulse Duration from 50 to 450 µS
3. Press the SET button again and the Clock [Time] symbol will flash on/
off, then press the+ or – button to adjust the time Channel A +/- button
to alter the hours and Channel B +/- button to adjust minutes.
[Maximum time 1 hour 30 minutes].
4. Press the SET button again and the WRK [Work] symbol will flash on/
off, then press the + or – button to adjust the work period from 2 –99
seconds.
5. Press the SET button again and the RST [Rest] symbol will flash on/
off, then press the + or – button to adjust the rest period 2 – 99 seconds.
6. Press the SET button again and the RMP [Ramp up] symbol will flash
on/off, then press the + or - button to adjust the ramp up period from
0.1 - 9.9 seconds.
7. Press the SET button again and ALT [Alternating] or SYN
[Synchronous] symbol will flash on/off, then press the + or – button to
select ALT or SYN.
8. If SYN [Synchronous] has been selected, press the SET button again to
set the required delay time of Ch. B stimulation after Ch. A one. DLY
will flash on the LCD display. Select the delay by pressing the Ch. B +/
- buttons to read the appropriate delay value (between 0.1 sec. and 4
sec)
After setting up the programme, press the ESC button to install and store the
customised programme. Repeat the above procedure to re-programme.
Note: You must press the ESC button before locking the unit.
NeuroTrac™ Sports Operation Manual
8