AEG P610 Operating Instructions Manual page 3

Revisioning of Operating Instructions P610
A91M.12-271893
This yellow page serves as a correction sheet for programming pa-
nels beginning with index .03.
→
The software kit "INSTAL Programming Unit" from P610 device index .03 has
been removed from active sales file of the P610. If you want to use the AEG
main menu it is necessary to order the software kit "INSTAL
Unit".
Starting with revision index .03 the programming panel P610 provides 5 MByte
RAM (4 MByte Expanded Memory). To use this memory it is necessary to install
the EMS driver that is included on the operating system diskette.
EMS Driver Installation
To install the driver it has to be entered into the file CONFIG.SYS. Please execu-
te the following steps:
Schritt 1 Use an ASCII editor of your device.
Schritt 2 Open the file CONFIG.SYS in your system directory.
Schritt 3 Add the following line in this file:
DEVICE=drive:\directory\EMM386.SYS[size]
(z.B. DEVICE=C:\DOS\EMM386.SYS [4096])
The number in brackets shows the size of the expanded
memory. Edit 4096 for 4 MByte memory.
Schritt 4 Store the file and close the editor.
Schritt 5 Reset the PADT with (<Ctrl>+<Alt>+<Del>)
Now the installation of the expanded memory is completed. Now you are able to
call up the software.
→
Programming
A