Table of Contents
Advertisement
PROBLEM
No dial tone.
Phone is dead.
Can make calls, but phone does
not ring.
Can receive, but cannot make
calls.
Static noise on line or cannot hear
cal l i ng par ty o r ca l l i n g pa rty
cannot hear you.
1. If problems with your telephone service occur later, try to determine if the trouble is
with the telephone or with the telephone company equipment. Unplug the telephone
and try it on another jack in a different room or in a neighborhood's home to see if the
phone line is bad or the phone.
2. If disconnection of your equipment ends the problem, your telephone may be the
source of the trouble and it should be tested and repaired if necessary before it is
reconnected.
3. There are no user maintainable parts or adjustments on this set. Should your phone
require repair, contact us for instructions (except for cords which you can buy at
any phone store).
TROUBLE SHOOTING
1. Plug disconnected from jack.
2. Jack improperly wired.
1. Damaged cord.
2. Jack improperly wired.
3. Line out of order.
RINGER switch in OFF position.
Slide the switch to ON position.
1. If your other telephones are "ROTARY" type
phones, your line may be conditioned to
accept PULSE dialing only.
Move TONE/PULSE switch to PULSE position.
2. Contact your phone company to have your
line changed to TONE and PULSE service.
Replace the coil cord. Any phone store has
these cords in different lengths.
11
LIKELY CAUSES
IB-PH417-WM-E-022804
Advertisement
Table of Contents
