Making An Audio Recording - Pioneer HTP-071 Operating Instructions Manual

03 Basic playback
03

Making an audio recording

You can make an audio recording from the built-in tuner, or
from an audio source connected to the receiver (such as a
CD player).
Only audio signals that were input to this receiver through a
analog audio inputs can be recorded. Signals that were input
through an HDMI cable or digital audio cable (optical /
coaxial) cannot be recorded (see Connecting other audio
components on page 15 for more on connections).
RECEIVER
SLEEP SOURCE
RECEIVER
INPUT SELECT
BD DVD TV
DVR/BDR CD CD-R
ADAPTER TUNER PORTABLE
PHASE S.RETRIEVER SIGNAL SEL
1 Press input function buttons to select the input function
you want to record.
The input of the receiver will switch over, and you will be able
to operate other components using the remote control.
• The input source can also be selected by using INPUT
buttons on the remote control, or by
SELECT
using the front panel INPUT SELECTOR dial.
2 Select the audio input signal (if necessary).
Press SIGNAL SEL and select the analog inputs (A) for the
source component of which you want to record (see page 17
for more on this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD etc.
20
En
4 Prepare the recorder.
Insert a blank tape, MD etc. into the recording device and set
the recording levels.
Refer to the instructions that came with the recorder if you
are unsure how to do this.
5 Start recording, then start playback of the source
component.
Note
• The receiver's volume, balance, tone (bass, treble,
loudness), and surround effects have no effect on the
recorded signal.
TV
CONTROL
DTV/TV
INPUT
CH
VOL