Table of Contents
Advertisement
TOSHIBA
2.0
Precautions
2.1
Installation Precautions
1)
2)
3)
4)
5)
6)
7)
8)
9)
2.2
Prestart Precautions
1)
2.3
Operating Precautions
1)
2)
3)
4)
5)
6)
Install the unit in a well ventilated location; allow at least 10 cm (4 inches) on
all sides for air ventilation and for maintenance.
Install the unit in a stable, level, and upright position which is free of vibration.
Install the unit in an environment where the ambient temperature is
between 0 to 40 deg C (32 to 104 deg F).
Do not install the UPS in areas that are subject to high humidity.
Do not allow direct sunlight to shine on the unit.
Do not install the UPS in areas which are subject to contamination such as
high levels of airborne dust, metal particles, or inflammable gas.
Avoid installation near sources of electrical noise and always make sure that
the unit ground is intact to prevent electrical shock and to help reduce
electrical noise.
Do not install where water or any foreign object may get inside the UPS.
This UPS generates and can radiate radio-frequency energy during operation.
Although RFI noise filters are installed inside the unit there is no guarantee
that the UPS will not influence some sensitive devices which are operating
close by. If such interference is experienced, the UPS should be installed farther
away from the effected equipment and/or powered from a different source than
that of the affected equipment.
Before connecting the UPS to a power source; move the ON/OFF switch, on
the front panel (See Section 8.1), to the OFF position.
The UPS should not be powered up until the entire operation manual has
been reviewed.
The input power source voltage must be within +10% to -30% of the rated input
voltage. The input frequency must be within the rated input frequency range.
Voltages and frequencies outside of the permissible tolerance range may cause
internal protection devices to activate.
The UPS should not be used with a load whose rated input is greater than the
rated UPS output.
Do not use the UPS to provide power to motors that require high starting current
or a long starting time such as vacuum cleaners and machine tools.
Do not insert metal objects or combustible materials in the unit's ventilation slots.
Do not place, hang, or paste any objects on the top or on the exterior surfaces
of the UPS.
2 - 1
Hide quick links:
Advertisement
Table of Contents
