Digital Cable Manual Search; Analogue Manual Search; Analog Fine Tune; Network Channel Scan - Hitachi L46VG09U Instructions For Use Manual

Digital Cable Manual Search

In cable manual scan, you can enter frequency,
modulation, symbol rate and network channel scan
options. After selecting search type as Digital Cable,
you can set the desired options and press OK button
to search.

Analogue Manual Search

After selecting search type as analogue, you can use
" "/" " button to highlight an item and then press "
" or " " button to set an option.
Enter the channel number or frequency using the
numeric buttons. You can then press OK button
to search. When the channel is located, any new
channels that are not on the list will be stored.

Analog Fine Tune

• Select Analog Fine Tune from the Installation menu
by using " " or " " and OK buttons. Analog fi ne tune
screen will be displayed. Analog Fine Tune feature
will not be available if there are no analog channels,
digital channels and external sources stored.
• Press OK button to proceed. Use " " or " " button
to set Fine Tune. When fi nished, press OK button
again.

Network Channel Scan

Select Network Channel Scan from the installation
menu by using " " or " " and OK buttons. Network
Channel Scan selection screen will be displayed.
Select Digital Aerial or Digital Cable and press
OK button to continue. The following message will
be asked. Select Yes to continue or select No to
cancel.
00_MB63D_[GB]_5100UK_DVB-TC_PLATINIUM6_46915LED_10070722_50178707_V1.indd 17 00_MB63D_[GB]_5100UK_DVB-TC_PLATINIUM6_46915LED_10070722_50178707_V1.indd 17
If you start Digital Aerial scan process, automatic
scanning will start. You can press "MENU" button
to cancel.
If you start Digital Cable scan process, the following
screen will be displayed.
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can set
Search Step as 8000 KHz or 1000 KHz. If you select
1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase
accordingly. When fi nished, press OK button to start
automatic search. Automatic searching screen will be
displayed during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.

Clear Service List (*)

(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press " " or
" " button to select Clear Service List and then press
OK. The following OSD message will be displayed
on the screen:
Press OK to cancel. Select Yes by pressing " " or " "
button and press OK to delete all of the channels.
English - 17 -
11.01.2011 17:02:17 11.01.2011 17:02:17