Customizing The Equalizer Curve; Eq7 Tune; Adjusting The Sound Characteristics - Sony XAV-W1 Operation Manual

Customizing the equalizer curve

— EQ7 Tune

"Custom" of EQ7 allows you to make your own
equalizer settings. You can adjust the level of 7
different bands: 62 Hz, 157 Hz, 396 Hz, 1 kHz,
2.5 kHz, 6.3 kHz, and 16 kHz.
1
During playback/reception, touch
"SETUP," the "Sound" tab, "EQ7," then
"Custom."
2
Touch "Tune."
The tuning display appears.
3
Touch +/– of each frequency to adjust
their levels.
The level is adjustable in single steps,
between –8 and +8.
To restore the factory-set equalizer curve,
touch "Reset."
4
Touch "OK."
The setting is complete.
To return to the previous display, touch
To close the setup menu, touch "SETUP."
Tip
Other equalizer types are also adjustable.
32
Adjusting the sound
characteristics
The sound balance between left and right
speakers ("Balance") and front and rear speakers
("Fader") can be adjusted to your preference.
You can also adjust the volume level of center
speaker and subwoofer if they are connected.
1
During playback/reception, touch
"SETUP," then the "Sound" tab.
The "Sound Setting" display appears.
2
Touch "Balance/Fader."
The setting display appears.
3
Touch I/i to adjust "Balance."
The level is adjustable in single steps,
between –10 and +10.
4
Touch U/u to adjust the "Fader."
The level is adjustable in single steps,
between –10 and +10.
5
Touch +/– of "Center" and
.
"Subwoofer" to adjust their volume
level.*
* Adjustable only when a center speaker is
connected and set to "Center Speaker ON"
(page 34), and a subwoofer is connected and set
to "Subwoofer ON" (page 34).
The level is adjustable in single steps,
between –6 and +6.
To return to the previous display, touch
To close the setup menu, touch "SETUP."
Note
"Balance/Fader" is not selectable while Zone × Zone is
activated.
.