The cord management feature is located on the back side
of the fan.
Simply double up the excess cord length, and place the two
pieces of cord in the notch (Fig 8b).
The notch will hold the cord so that the excess length will not
drag on the ground.
REMOTE CONTROL BATTERY INSTALLATION/
A. Remove battery door by sliding downward in direction of
B. Insert 2 AAA batteries into the remote following the directional
guides in the recessed slots (Fig. 9). Batteries are included.
C. R eplace battery door by sliding upward opposite of arrow
direction until door snaps in place.
NOTE: DO NOT MIX OLD AND NEW BATTERIES. DO NOT MIX ALKALINE, STANDARD
(CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
SEE RECYCLERS IN YOUR AREA FOR PROPER DISPOSAL OF BATTERIES.
HY-254 SERIES FAN OPERATION
To turn fan on, press the Power button ( )
located on the left side of the control panel.
The fan will automatically start on "Sleep" speed
when initially turned on. To adjust
the speed up or down, press the Fan Speed
button ( ) repeatedly to increase level.
To activate the Oscillation feature, press the
Oscillation button ( ) once.
Press the Oscillation button again to turn the
Oscillation feature off.
Choose from 1, 2, 4, or 8 hour settings by
performing the following function:
• 1 hour: Press the Timer button ( ) once.
• 2 hours: Press the Timer button twice.
• 4 hours: Press the Timer button a third time.
• 8 hours: Press the Timer button a fourth time.
Press the Timer button a fifth time to turn the Timer feature off.