Picture Id - LG 55LV75A Owner's Manual

52
CUSTOMIZING SETTINGS

Picture ID

Picture ID is used to change the settings of a
specific display using a single IR receiver for
multi-vision. The set receiving the IR signal
communicates with another set via an RS-232C
connection. Each set is identified by a Set ID. If
you assign the Picture ID using the remote control,
only displays with the same Picture ID and Set ID
can be controlled remotely.
AUDIO
(RGB/DVI)
RS-232C OUT
RS-232C IN
REMOTE
CONTROL IN
IR Receiver
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
1
Press the red ON button on the remote control
to assign the Picture ID.
2
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
Picture ID
◄ Off ►
Close
To change the Picture ID, press the ON button,
or the left and right arrow buttons continuously.
Assign the ID you want.
Picture ID
Off
◄
Close
If you assign the Set ID to each set with
y
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
with the same Set ID and Picture ID. A set
with different Set IDs and Picture IDs cannot
be controlled by IR signals.
The maximum value of the Picture ID can be
y
set in the Total Set ID menu.
Please refer to the Installation Manual for
y
more information on Total Set ID assignment.
NOTE
For example, if the Picture ID is assigned to
y
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
For each set, you can change the settings
y
for the PICTURE, AUDIO, TIME, NETWORK
and MY MEDIA menus or the hot keys on the
remote control.
If you press the green OFF button for Picture
y
IDs, the Picture IDs for all sets are turned off.
If you then press any button on the remote
control, all sets will start working again.
Picture ID will be disabled while using the
y
MY MEDIA menu.
If Picture ID is set to Off, holding buttons
y
on the remote control will execute only one
action at a time.
►