responsibility of the professional installer to ensure to control the output power not
grater then the application.
The OEM integrator has to be aware not to provide information to the
end user regarding how to install or remove this RF module in the user's
manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as
show in this manual.
Users manual of the end product:
In the users manual of the end product, the end user has to be informed to keep
at least 20cm separation with the antenna while this end product is installed and
operated. The end user has to be informed that the FCC radio-frequency exposure
guidelines for an uncontrolled environment can be satisﬁed. The end user has to
also be informed that any changes or modiﬁcations not expressly approved by the
manufacturer could void the user's authority to operate this equipment.
The FCC part 15.19 statement below has to also be available in the
This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Label of the end product:
The ﬁnal end product must be labeled in a visible area with the following "Contains
TX FCC ID: N89-MW600BLO".
This device is intended only for OEM integrators under the following
1) The antenna must be installed such that 20 cm is maintained between the
antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or
MW600-B-LO Wireless 802. 11b/g wireless PCI-E Adapter Card
Manual Information To the End User
2008.11.7 10:59:26 AM