Functional Description; Charging The Built-In Battery - Makita CL104D Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off before
•
adjusting or checking function on the tool.

Charging the built-in battery

CAUTION:
Do not operate the cleaner during charging. It may
•
be damaged.
Always disconnect the charging plug from the
•
cleaner after charging.
When you charge a new cleaner or a cleaner
•
which has been left uncharged for a long time, it
may not accept a full charge. This is a normal
condition and does not indicate a problem. You
can recharge the cleaner fully after discharging it
completely a couple of times.
1
014724
014723
Use only the Makita charger DC1001 to charge this
cleaner. Use of the other type chargers may cause the
battery to burst, result in personal injury and damage.
Charge the cleaner when using it for the first time or
uncharged for a long time. Connect the charging plug to
the charging connector, then plug in the charger to the
power receptacle. The battery power lamp lights up and
start charging. Charging takes approximately 3 hours.
The light goes out after the charging is complete. For
more details, refer to the instruction manual of battery
charger.
1. Charging
connector
1. Battery power
lamp
1
Switch action
CAUTION:
Always be sure that the dust bag or paper pack is
•
installed properly in the cleaner before use.
Improper installation may allow dust to enter the
motor, resulting in malfunction of the cleaner.
Always switch off the cleaner after each use to
•
prevent damage to the cleaner and to extend the
service life of the batteries.
014725
To start the cleaner, simply press the "1/2/3" button. To
switch off, press the "0" button. To change the cleaner
speed, press the "1/2/3" button. The first press on this
button is for high speed and the second press for low
speed. Each press on this button repeats the high/low
speed cycle alternatively.
While pressing the "1/2/3" button, this cleaner works
with turbo. This mode is appropriate to clean especially
dusty area.
Battery power lamp
014723
When the remaining battery capacity gets low, the
battery power lamp blinks.
When the remaining battery capacity gets much lower,
the tool stops and the battery power lamp lights up
about 10 seconds. At this time, charge the cleaner.
NOTE:
The time at which the battery power lamp start
•
blinking or lighting up depends on the temperature
at work place and the battery cartridge conditions.
4
1. Switch buttons
1
1. Battery power
lamp
1