Network; Basic Network Settings - Panasonic KX-TGP600 Administrator's Manual

Value Range

4.3 Network

This section provides detailed descriptions about all the settings classified under the [Network] tab.

4.3.1 Basic Network Settings

This screen allows you to change basic network settings such as whether to use a DHCP server, and the IP
address of the unit.
Note
•
Changes to the settings on this screen are applied when the message "Complete" appears after clicking
[Save]. Because the IP address of the unit will probably be changed if you change these settings, you
will not be able to continue using the Web user interface. To continue configuring the unit from the Web
user interface, log in to the Web user interface again after confirming the newly assigned IP address
of the unit using the phone user interface. In addition, if the IP address of the PC from which you try to
access the Web user interface has been changed, close the Web port once by selecting "Off" for
Document Version 2015-02
•
Registered: The unit has been registered to the SIP server, and the
line can be used.
•
Registering: The unit is being registered to the SIP server, and the
line cannot be used.
•
Blank: The line has not been leased, the unit has not been
configured yet, or a SIP authentication failure has occurred.
Note
•
Immediately after starting up the unit, the phone numbers of the
lines will be displayed, but the status of the line may not be
displayed because the unit is still being registered to the SIP
server. To display the status, wait about 30 to 60 seconds, and
then click [Refresh] to obtain updated status information.
4.3.1 Basic Network Settings
Administrator Guide 79