Setup; Factory Defaults; Language Selection For The Unit; Basic Network Setup - Panasonic KX-TGP600 Administrator's Manual

Sip
Hide thumbs Also See for KX-TGP600:
Table of Contents

Advertisement

1.1.3 Basic Network Setup

1.1 Setup

1.1.1 Factory Defaults

Many of the settings for this unit have been configured before the unit ships.
Where possible, these settings are configured with the optimum or most common values for the setting. For
example, the port number of the SIP (Session Initiation Protocol) server is set to "5060".
However, many of the settings, such as the address of the SIP server or the phone number, have not been
pre-configured, and they must be modified depending on the usage environment. If the port number of the SIP
server is not "5060", the value of this setting must be changed.
This unit thus will not function properly using only the factory default settings. The settings for each feature
must be configured according to the environment in which the unit is used.

1.1.2 Language Selection for the Unit

You can change the language used on the LCD.
In addition, various settings can be configured by accessing the Web user interface from a PC on the same
network (® see Section 4 Web User Interface Programming). You can select the language for the Web
user interface.
Note
To select the display language for the unit, refer to the Operating Instructions on the Panasonic Web
site (® see Introduction).
To select the display language for the Web user interface, see 4.4.2 Language Settings.
1.1.3 Basic Network Setup
This section describes the basic network settings that you must configure before you can use the unit on your
network.
You must configure the following network settings:
IP Address Mode (IPv4 or IPv6 or IPv4/IPv6 Dual) settings
TCP/IP settings (DHCP / RA for IPv6 / static IP)
DNS server settings
For details about basic network settings via the Web user interface, see 4.3.1 Basic Network Settings.
TCP/IP Settings for IPv4 (DHCP or Static IP Address Assignment)
A unique IP address must be assigned to the unit so that it can communicate on the network. How you assign
an IP address depends on your network environment. This unit supports the following 2 methods for assigning
an IP address:
Obtaining an IP Address Automatically from a DHCP Server
You can configure the unit to automatically obtain its IP address when it starts up from a DHCP server running
on your network. With this method, the system can efficiently manage a limited number of IP addresses. Note
that the IP address assigned to the unit may vary every time the unit is started up.
For details about the DHCP server, consult your network administrator.
22
Administrator Guide
Document Version 2015-02

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents