Customizing The Buttons - Panasonic KX-NCP500 Operating Manual

3.1.4 Customizing the Buttons

You can customize the flexible buttons and/or programmable feature (PF) buttons on PTs, Add-on Key
Modules, and PSs. They can then be used to make or receive outside calls or as feature buttons.
•
To enter the programming mode when using a PS, refer to "Operating Instructions" for the
PS.
•
The buttons in the table below can only be set on certain flexible buttons, as follows:
–
Flexible buttons on PTs/Add-on Key Modules/PSs: all buttons can be set.
–
Flexible buttons on DSS Consoles: all buttons except CTI and Primary Directory Number
(PDN) buttons can be set.
–
Programmable feature (PF) buttons: only the One-touch Dialing button can be set.
To enter the program mode
PROGRAM
OR
PAUSE
Press PROGRAM
or PAUSE.
Button
Loop-CO (L-CO)
Group-CO (G-CO)
Single-CO (S-CO)
Direct Station Selection (DSS)
One-touch Dialing
*1
Incoming Call Distribution
Group (ICD Group)
Message
Message for Another Extension
Call Forwarding (FWD)/Do Not
Disturb (DND)—Both calls
FWD/DND—Outside calls
FWD/DND—Intercom calls
Group FWD—Both calls
Document Version 2013-05
To program
To continue
programming
input
Follow
Press desired
programming
flexible button.
input.
#
+ CO line group no. (2 digits)
0 + CO line no. (3 digits)
1 + Extension no.
2 + Desired no. (max. 32 digits)
*²
3 0
+ Incoming call distribution group extension no. (+
# + delayed ringing time [0–7])
4 0
4 0
+ Extension no./Incoming call distribution group extension
no.
4 1
4 2
4 3
4 4 + Incoming call distribution group extension no.
3.1.4 Customizing the Buttons
To exit
PROGRAM
OR
AUTO DIAL
STORE
Press PROGRAM
Press ENTER
or PAUSE.
or STORE.
Programming Input
*5
OR
PAUSE
Operating Manual 191