How To Cancel The Auto Restart Function; Power Failure During Timer Operation - Toshiba RAS-10SKVP2-E Service Manual

9-3-2. How to Cancel the Auto Restart Function

To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the signal and beeps three times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
• When the system is on stand-by (not operating)
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
Hi POWER FILTER PAP
RESET button
• When the system is operating
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
Hi POWER FILTER PAP
RESET button

9-3-3. Power Failure During Timer Operation

When the unit is turned off because of power failure
during timer operation, the timer operation is can-
celled. In that case, set the timer operation again.
NOTE :
The Everyday Timer is reset while a command signal
can be received from the remote controller even if it
stopped due to a power failure.
The unit is on standby.
The unit starts to operate.
The unit beeps three times and continues to operate.
If the unit is not required to operate at this time, press [RESET]
TIMER OPERATION
button once more or use the remote controller to turn it off.
RESET
The unit is in operation.
The unit stops operating.
The unit beeps three times.
If the unit is required to operate at this time, press [RESET] button
TIMER OPERATION
once more or use the remote controller to turn it on.
RESET
Motions
↓
↓
After approx. three seconds,
Motions
↓
↓
After approx. three seconds,
– –
43
FILE NO. SVM-11015
The green indicator is on.
The green indicator is on.
The green indicator is turned off.