One-Touch Comfort; Hi-Power Mode; Fil Ter Indicator - Toshiba RAS-10SKVP2-E Service Manual

Item
19. One-Touch
One touch comfort is the fully automated operation
Comfort
that is set according to the preferable condition in
a region.
Fan
Operation
*AUTO/L: Fan operates depends on the setting
temperature and room temperature.
During the One Touch Comfort mode if the indoor
unit receives any signal with other operation mode,
the unit will cancel the comfort mode and operates
according to the signal received.
20. Hi-POWER
([Hi-POWER] button on the remote controller
Mode
is pressed)
When [Hi-POWER] button is pressed while the indoor
unit is in Auto, Cooling or Heating operation, Hi-
POWER mark is indicated on the display of the remote
controller and the unit operates as follows.
1. Automatic operation
• The indoor unit operates in according to the
2. Cooling operation
• The preset temperature drops 1ºC
3. Heating operation
• The preset temperature increases 2ºC
4. The Hi-POWER mode can not be set in Dry
operation
21. FILTER When the elapsed time reaches 1000 hours after air
Indicator
purifier operation, the FILTER indicator lights.
After cleaning the filters, turn off the FILTER indicator.
How to Turn Off FILTER Indicator
Press [RESET] button on the indoor unit.
NOTE :
If [RESET] button is pushed while the FILTER indicator
is not lit, the indoor unit will start the automatic
operation.
When you want a temporary operation while the
FILTER lamp lights, press [RESET] button to turn off
the FILTER lamp. (See page 42)
Operation flow and applicable data, etc.
AUTO * AUTO/L
0 12 25
current operation.
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increase 1 tap
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increase 1 tap
Operation condition for model to Europe
market
When an indoor unit receives "One Touch
Comfort Signal" from the remote controller,
the indoor unit operates as following.
1) Air conditioner starts to operation when
L
2) Operation mode is set according to room
3) Target temperature is 24ºC.
Time after operation
4) Louver position is set as stored position
starts (min)
5) Fan is controlled as followings.
− 40 −
FILE NO. SVM-11015
Description
the signal is received, even if the air
conditioner was OFF.
temperature, the same as AUTO mode.
of the operating mode.
.