DRYER EXHAUST CHANGE
DUCT
TAPE
65
1.
Remove the screw.
2-1.
Detach and remove a knockout at the botton,
left or right side as desired. (Right side vent not
available on gas dryer)
,
,
the order of work.
2-2.
Replace it with an 11-inch (28 cm) duct
connected to the blower housing, and attach
the duct to the base. (The side vent kit is
available as a service part, # 383EEL9001B.)
3-1.
Pre-assemble a 4-inch elbow to a piece of duct.
Wrap duct tape around the joint.
3-2.
Insert the elbow duct assembly through the side
opening and connect the elbow to the internal
duct.