Electrolux EDW 1003 Service Manual page 26

6.7.1. Input philosophy: alter program
l
Alter program during the prestart phase
The door is still open at that moment!
LD3
1.
LD5
2.
S5
LD2
3.
S2
1. Program has been selected but did not yet start.
Ä Corresponding program LED is lit.
2. By pressing the new desired program key shortly it is possible to alter directly.
Options already selected before are cleared and have to be selected anew.
Ä New selected program LED is lit.
3. Before the door has been closed it can be altered as many times as one wants.
Only when the door has been closed, the program will start automatically.
Special feature when a start time was selected before!
1. Program and start time have been selected but did not yet start.
Ä Cycle LED and "SZV" LED are lit.
2. By pressing the new desired program key shortly it is possible to alter directly.
The already selected start-time preselection keeps to be after the alteration! Cycle options selected
before however are deleted and have to be selected anew.
Ä New cycle LED and "SZV" LED are lit.
If the selected start time is already running down (the time in the display is lit permanently) you have to press the
new desired cycle key a longer time (about 6 seconds).
26
EDW 1003 / VGA
LD1 LD2 LD3 LD4 LD5 LD6
LD7
LD8
LD9
S1 S2 S3 S4 S5 S6
LD10
LD11
LD12
S0