Electrolux EDW 1003 Service Manual page 16

5.2.1 Water load steps (Example)
speed
in U /
min
target-
speed
1600
water
in L
3,6 - 4
ca. 1,6
valve
on
off
Static filling
- Static filling until pressure switch point.
failure code:
If this point isnt reached after max. 2 minutes (Timeout 1), a
failure code is displayed and the program is stopped.
Dynamic filling
- 10 seconds filling at reduced circulation pump speed
- 5 seconds pause
- 10 seconds filling at reduced circulation pump speed
- filling with increasing circulation pump speed. As soon as the
target speed has been reached, it is filled up to the pressure
switchpoint.
Failure code:
If this dynamic switchpoint isn't reached within total 4 minutes
(Timeout 2), the dynamic filling can be repeated 3 times. Only
after non-successful repeating 3 times, a failure code is displayed
and the program is stopped.
pulse wash pulse 2800 1/min
1
2
3
09.2002 R.K.
static water
load
to level
Timeout 1
Timeout 2
10 Sek.
0
level c heck:
water failure displayed
if level not reac hed!
dynamic
water load
static
water load
0
filing filling is possible
Pause 1600 1/min target speed in dynamic filling
0,9 sec 4,5 sec
0,6 sec
0,3 sec 1,5 sec
dynamic water
load
wit h level control
≥20 Sek.
5 Sek.
5 Sek.
level c heck:
water failure displayed
if level not r eac hed!
3 sec
- 16 -
max. 4
repetitions
time
in Sek.
time
in Sek.
time
in Sek.
*) The target speed
is dependent on
the subsequent
pulse wash.
2200 1/min
1900 1/min
1700 1/min
599 515 183 EN