International Electrical Symbols; Cenelec Directives - Brymen BM252 User Manual

WARNING
To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. To avoid
electrical shock hazard, observe the proper safety precautions when working with voltages above 60
VDC or 30 VAC rms. These voltage levels pose a potential shock hazard to the user. Do not touch
test lead tips or the circuit being tested while power is applied to the circuit being measured. Keep
your fingers behind the finger guards of the test leads during measurement. Inspect test leads,
connectors, and probes for damaged insulation or exposed metal before using the instrument. If any
defects are found, replace them immediately. Do not measure any current that exceeds the current
rating of the protection fuse. Do not attempt a current measurement to any circuit where the open
circuit voltage is above the protection fuse voltage rating. Suspected open circuit voltage should be
checked with voltage functions. Never attempt a voltage measurement with the test lead inserted
into the A/mA or A input jack. Only replace the blown fuse with the proper rating as specified in this
manual. Only use the test lead provided with the equipment or UL Listed Probe Assembly with rating
or better.
CAUTION
Disconnect the test leads from the test points before changing functions. Always set the instrument
to the highest range and work downward for an unknown value when using manual ranging mode.

INTERNATIONAL ELECTRICAL SYMBOLS

Caution ! Refer to the explanation in this Manual
!
Caution ! Risk of electric shock
Earth (Ground)
Double Insulation or Reinforced insulation
Fuse
AC--Alternating Current
DC--Direct Current

2) CENELEC DIRECTIVES

The instruments conform to CENELEC Low-voltage directive 2006/95/EC and Electromagnetic
compatibility directive 2004/108/EC
2