Completing The Fru Replacement - Lenovo ThinkCentre 3656 Hardware Maintenance Manual

3. Remove the new adapter from its static-protective package.
4. Install the new adapter into the appropriate connector on the system and close the adapter latch.
5. Go to "Completing the FRU replacement" on page 113.

Completing the FRU replacement

After replacing FRUs, you need to install any removed parts, replace the cover, and reconnect any cables,
including telephone lines and power cords. Also, depending on the FRU that is replaced, you might need to
confirm the updated information in the Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn on for a few seconds and
then turn off. This is a normal sequence to enable the computer to initialize.
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer.
2. Reposition any cables that might impede the replacement of the computer cover.
Important: Correctly route all power supply cables to avoid interference with the drive bay assembly.
Keep cables clear of the hinges and sides of the computer chassis.
3. Position the computer cover on the chassis so that the rail guides on the sides of the cover engage the
rails and push the cover to the closed position until it snaps into position.
Chapter 9 Replacing FRUs (Types 7057, 7062, 7092, 9342, 9344, 9354, 9426, 9486, 9624, 9707, 9787, 9804, 9945)
113