Commissioning And Operation; Dry Vacuum Cleaning - Kärcher MV 2 Operating Instructions Manual

Commissioning and
operation
Caution
Always work with an inserted
cartridge filter during wet as well
as dry vacuum cleaning!
Attaching the Accessories
Illustration
Remove the appliance head and

take accessories out of the contain-
er.
Illustration
Fit the swivel casters on the con-

tainer bottom.
Illustration
Put the appliance head onto the

container and lock it.
Illustration
Connect accessories.

Note: For vacuuming dry dirt or water
off the floor - always work with the in-
sert (brush strip and rubber lip) in the
floor nozzle.
Illustration
Connect the mains plug and turn on

the appliance.

Dry vacuum cleaning

Caution
Work with a dry cartridge filter
only!
Check the filter for damage prior
to installation and replace as
necessary.
Vacuum cold ashes only when
using a pre-filter.
Order no. basic design: 2.863-139.0,
premium design: 2.863-161.0.
8 English
Wet vacuum cleaning
Caution:
Do not use a filter bag!
Immediately switch the appliance off if
foam forms or liquids escape!
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Note: If the container is full, a float
closes the suction opening, and the ap-
pliance works at a higher speed.
Switch off the appliance immediately,
and empty the container.
Finish operation
Illustration
Turn off the appliance and discon-

nect the mains plug.
Empty the container
Illustration
Remove the appliance head and

empty the reservoir.
Storing the appliance
Illustration
Stow away the mains cable and ac-

cessory at the machine. Store the
appliance in a dry room.