Advertisement
Launch the X-CAM Gimbal Assistant, choose the correct port number and click CONNECT
On a successful connection the A10-3H should beep twice, the parameters will be read automatically.
The parameters as below:
1.
Gains
There are 2 gains, Position Gain and Acceleration Gain
Pos. Gain: Inclined the gimbal to one position slowly and watch the video image is horizontal or not, if not please adjust the Pos. Gain
in the software .
Acc. Gain: After adjusting the Pos. Gain, Inclined the gimbal to one position quickly and watch the video image is horizontal in time, if
not please adjust the Acc. Gain in the software .
Notice: the X-CAM A10-3H has been finished the adjusting, does not need to adjust again in normally
2.
Gimbal Control
The A10-3H provides 2 ways to control TILT, Linear Mode or Tracking Mode
Linear Mode: TILT changes when the control stick is moved from the center position. TILT holds position while control stick is
centered.
Tracking Mode: TILT follows the position of the control stick. Often used with the throttle control, as it does not self center.
Advertisement
