Final Finishing; Break-In Period; Control Panel Operation - Lennox Hearth Products MPE-36R Installation Instructions And Homeowner's Manual

FINAL FINISHING

Materials such as brick and tile can be extended
down to the top of the fi replace. Do not extend
down, covering the outlet or glass enclosure
panel (optional kit).
There are a wide variety of "fi nished looks" for
these fi replaces, from formal wall decor with
elaborate mantels to rustic wood paneling or
warm brick facings.
Mantel Cabinet or Accent Trim Installations
An optional mantel cabinet kit or an accent trim
kit is available from your dealer (see page 18).
These options give the appliance an attractive
fi nished look.
Hearth
An aesthetically pleasing fi replace hearth can
be installed, if desired (see hearth protection
on page 5).

BREAK-IN PERIOD:

During the fi rst few initial uses of this heater,
there may be a release of a slight, harmless odor.
This odor is a normal occurrence caused by the
initial heating of the internal heating elements
and should not reoccur.
6
MANUAL CONTROL PANEL OPERATION
(refer to Figures 5 & 6)
Once this appliance has been properly installed
and connected to the power supply as defi ned
in this manual, it is ready to operate.
Note: Ensure the circuit breakers for the power
supply are turned on.
This appliance can be operated either from the
manual control panel (see Figures 4 & 5) or by
using the remote control, wall switch or wall
thermostat (optional kits).
The manual controls are located on the fi rebox
fl oor on the front left (see Figure 5). If an
optional glass enclosure is installed, it must
be removed to access.
Main Power ON/OFF Switch
When the main power switch is turned on,
power is supplied to the fi replace. This switch
must be on for all other switches to operate.
Heater ON/OFF Switch
When this switch is turned on, the heater will
emit heat in the temperature range selected (see
Figure 6; G, H & I). The fi replace can operate
with or without heat.
Flame / Ember On/Off Switch:
Turns lights on inside ember bed and fl ame
cylinder.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
MANUAL CONTROL PANEL
Main Power On/Off
(rear most switch)
On
Heater On/Off
(center switch)
On Off
Flame / Ember On/Off
(front most switch)
Off
On
Figure 4
Manual Control Switches
are located behind pull
screen on inside fl oor
Figure 5
• When using the main power on/off switch
inside the body, the power on/off switch
outside the body (optional wall switch kit)
must be in the OFF position.
• When using power on/off switch outside
the body (optional wall switch), the power
on/off switch inside the body must be in
the OFF position.
• When using the remote control, the power
on/off switch inside the body and the wall
switch (optional kit) must be on the OFF
position.
Off