Arboria Heritage Arbor Assembly Instructions

COMPONENTS LIST
Arbor side panels (2)
1
2
Headers (2)
Braces (4)
3
Caps (7)
4
Wings (2)
5
Post sleeves (2)
6
7 Post Base Kit (2)
Post caps (2)
8
(Hardware included)
YOU WILL NEED
Tools and Supplies
for Arbor
Phillips screwdriver
Tape measure
Carpenter Square
Pre-mix concrete (120lb)
(optional)
PRELIMINARIES
IF YOU PLAN TO PAINT
If you wish to stain or paint your arbor/entry, we recommend that you do so before assembly, this will make the product
easier to install. Be careful not to cover up guide marks on the rafters.
WORK AREA
Select an area close to where the arbor/entry will be installed. The assembly area should be relatively flat and open with
at least 8'x6' of space. We recommend the use of the shipping box as your work surface to protect the arbor/entry
against damage during assembly.

ASSEMBLY INSTRUCTIONS

Heritage Arbor/Grand Entry
PLEASE READ THROUGH BEFORE STARTING ASSEMBLY
Complete
Assembly
Components 5-8
included with
Grand Entry Only
6
Additional Tools and
Supplies for Grand Entry
5' Pressure treated 4x4
posts (2)
2" Galvanized trim head
nails
Concrete mixing tools
Wood shims
Wood adhesive
Pre-mix concrete (120lb)
445.35.100
Division of LWO Corp. / P.O. Box 17125 / 3841 North Columbia Boulevard / Portland, Oregon
503-286-5372 / fax 503-286-4092
4
5
HARDWARE PROVIDED
Arbor only
2 1/2" screws (8)
3 1/2" screws (22)
9 7/8" spacer block
Anchor stake kit
1 of 4 9/29/2006
2
3
1
Additional Hardware
(Included with Grand Entry)
2 1/2" washer head screws (8)
#2 square head driver bit
3/4" screws (8)
Anchors (4)
HA
8
7