Sony BKM-16R Operation Manual page 8

Display window: Displays the
selected ID number or ALL. The
display flashes until the remote
connection is completed. "---" is
displayed when the monitor and
controller are in 1 to 1 connection
(PEER TO PEER mode
connection).
REMOTE
SINGLE
GROUP
ALL
SINGLE GROUP ALL
Lamps: The lamp
corresponding with the
pressed button flashes and
lights after recognizing the
monitor.
i MANUAL adjustment buttons and knobs
Each time one of these buttons is pressed, the LED on the
button lights in green or turns off. When the corresponding
button is set to on (lit), it is possible to manually adjust the
contrast, brightness (black level), chroma (color saturation)
and phase by turning the corresponding knobs.
When the corresponding button is set to off, the picture
adjustment preset value set in the menu of the monitor is
applied.
It is possible to set the preset value for each knob in the
menu of the monitor.
The PHASE knob is also used to enter the setting values in
the menus of the monitor.
PHASE CHROMA
button and button and
knob knob
CHROMA
PHASE
MANUAL MANUAL
8
Location and Function of Parts
SINGLE button: Selects
single connection mode.
The designated monitor is
connected remotely.
The monitor ID number is
displayed on all connected
monitors when the button is
held pressed.
GROUP button: Selects
group connection mode.
The monitor of the designated
group is connected remotely.
The group ID number is
displayed on all connected
monitors when the button is
held pressed.
ALL button: Selects all
connection mode.
All monitors are connected
remotely.
BRIGHT CONTRAST
button and button and
knob knob
BRIGHT CONTRAST
MANUAL MANUAL
Note
The button and knob may not function due to the input
signal. For the limitations with each type of signal, refer to
the manual of your monitor.