Nokia E5-00 User Manual page 75

access point marked with
Edit.
Use the instructions provided by your
service provider to edit the following:
Connection name — Define a name for
the connection.
Data bearer — You might not be able
to edit the data bearer once defined.
Define a new access point if needed.
WLAN network name — Select
manually or Search for
you select an existing network,
network mode
mode are determined by the settings of
its access point device.
Network status — Define whether the
network name is displayed.
WLAN network mode — Select
hoc to create an ad hoc network, and to
allow devices to send and receive data
directly; a WLAN access point device is
not needed. In an ad hoc network, all
devices must use the same WLAN
network name.
WLAN security mode — Select the
encryption used: WEP, 802.1x, or
WPA2. (802.1x and WPA/WPA2 are not
available for ad hoc networks.) If you
© 2010 Nokia. All rights reserved.
, and select
networks. If
WLAN
and WLAN security
select Open
used. The WEP, 802.1x, and WPA
functions can be used only if the
network supports them.
Use access point — Select
confirmation
for confirmation before the connection
using this access point is created or
Automatically
connect to the destination using this
access point automatically.
Enter
To enter the settings for the selected
security mode, select
settings.
Advanced WLAN settings
Select Options
and from the following:
Ad-
IPv4 settings — Enter the IP address of
your device, the subnet IP address, the
default gateway, and the IP addresses
of the primary and secondary DNS
servers. Contact your internet service
provider for these addresses.
IPv6 settings — Define the type of DNS
address.
WPA/
Ad-hoc channel (only for ad hoc
networks) — To enter a channel
Connectivity
network, no encryption is
After
to set the device to ask
to set the device to
WLAN security
Advanced settings
>
75