Disassembly And Assembly - Pride Laser Owner's Manual

I X . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
No tools are required to disassemble or assemble your Laser. Always disassemble or assemble your Laser on a
level, dry surface with sufficient room for you to work and move around your Sport Scooter. Keep in mind that the
disassembled sections of the Laser take up more floor space than the assembled Laser.
You can disassemble the Laser into seven pieces: the seat, the front section, the rear section, the rear shroud, the
basket, and the batteries. Place the Sport Scooter in an area where you have sufficient clearance to move the parts
around. You need about four or five feet in all directions. You may need assistance to lift some of the Sport Scooter
components. See IV. “Specifications” for individual component weights.
Before beginning disassembly, place the manual freewheel lever in the drive (down) position and coil the charger
power cord for storage in the rear storage compartment. See figure 8.
WARNING! If you believe that lifting any component of the Laser is beyond your physical capabil-
ity, have someone with ample strength lift it for you.
1. Gently lift the seat up and off of the Laser. See figure 18.
2. Gently lift the rear shroud off of the Laser. See figure 19.
3. Disconnect the battery tie-down straps (if so equipped).
4. Unplug both black and white 2-pin battery harnesses. See figure 20.
5. Unplug the silver front-to-rear harness that connects the control console assembly to the electronics module.
See figure 21.
6. Lift both batteries off of the Laser. See figure 22.
CAUTION!
disassembly could result in permanent damage to the Laser.
7. Grab the handle grip on the tiller, pull upward on the tiller adjustment lever, and gently lower the tiller down to
the center of the Laser chassis until it is fully lowered.
8. Push the locking cam levers forward and remove the ball detent pins. See figures 23 and 24.
9. Gently slide the two sections of the Sport Scooter apart. See figure 25.
FIGURE 18. SEAT REMOVAL
28
Failure to unplug both battery harnesses and the front-to-rear harness prior to
FIGURE 19. SHROUD REMOVAL
Laser