Operation - Fujitsu INVERTER ASBA18JCC Operating Manual

OPERATION

To Select Mode Operation
1
Press the START/STOP button (Fig.6 Q).
The indoor unit's OPERATION Indicator Lamp (red) (Fig. 3 5) will light.
The air conditioner will start operating.
2
Press the MODE button (Fig.6 K) to select the desired
mode.
Each time the button is pressed, the mode will change in the following order.
 AUTO
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. button (Fig. 6 L).
button: Press to raise the thermostat setting.
button: Press to lower the thermostat setting.
● Thermostat setting range:
AUTO ....................................18-30 °C
Cooling/Dry ...........................18-30 °C
The thermostat cannot be used to set room temperature during the FAN mode (the tem-
perature will not appear on the Remote Control Unit's Display).
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ some-
what from the actual room temperature.
To Set the Fan Speed
Press the FAN button (Fig. 6 P).
Each time the button is pressed, the fan speed changes in the following order:
AUTO
 
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling : As the room temperature approaches that of the thermostat setting, the fan
speed becomes slower.
Fan : The fan runs at the low fan speed.
The fan will operate at a very low setting during Monitor operation.
SUPER QUIET Operation
When set to Quiet:
SUPER QUIET Indicatior Lamp (orange) (Fig. 3 7) will right.
SUPER QUIET operation begins. The indoor unit's airfl ow will be reduced for quieter
operation.
● SUPER QUIET operation cannot be used during Dry mode. (The same is true when
dry mode is selected during AUTO mode operation.)
● During Super Quiet operation, Cooling performance will be reduced somewhat. If the
room does not cool down when using SUPER QUIET Operation, please adjust the air
conditioner's Fan Speed.
En-5
 COOL  DRY
HIGH MED LOW
 
 FAN
QUIET

START
STOP
SET
SET
SET
TEMP.
SLEEP SWING
Example: When set to COOL.
START
STOP
SET
SET
SET
TEMP.
SLEEP SWING
Example: When set to 26 °C.
START
STOP
SET
SET
SET
TEMP.
SLEEP SWING
Example: When set to AUTO.