Polaris Slingshot SL 2015 Owner's Manual page 39

Turn the ignition key to the ON position before performing the electrical pre-ride
inspections. Return the ignition key to the OFF position after completing these inspections.
If inspection of any electrical item reveals component failure, repair or replace the
component before operating the vehicle.
Item
Front Lights
Rear Lights
Turn Signals
Emergency
Flashers
Horn
Low Oil Pressure
Indicator
Steering
Engine Oil Level
Fuel Level
Coolant Level
Tires
Wheels
Brake Fluid Level
Park Brake
Brake System
Throttle Pedal
Clutch System
Front Suspension
Rear Suspension
Drive Belt
Fasteners
Mirrors
Turn the ignition key on. Verify that the headlights, auxiliary lights (if
equipped) and park lamps illuminate. Switch to high beam. Verify that
the high beam indicator comes on and that headlamp brightness
increases. Adjust headlight aim as needed.
Verify that the taillights and license plate light illuminate. Apply the
brakes and verify that the taillight lamps increase in brightness.
Verify that the left and right turn signals flash at the front and rear of the
vehicle, and that the corresponding indicator lamp flashes in the gauge.
Press the top of the hazard switch to turn the flashers on. Verify that all
four turn signals flash, as well as the lamps in the gauge. Press the
bottom of the switch to turn the flashers off. Verify that all signals and
indicator lamps stop flashing.
Press the horn button. Verify that the horn sounds loudly.
Start the engine and verify that the low oil pressure lamp does not
illuminate.
Check power steering for smooth operation.
Check the oil level.
View the fuel gauge to check the fuel level.
Check the recovery bottle coolant level.
Inspect tire condition, pressure and tread depth.
Inspect for loose, damaged or missing wheel nuts.
Check the master cylinder brake fluid level.
Verify that the vehicle does not roll when the park brake is set.
Inspect brake system hoses, connections and brake pads. Check brake
pedal for excessive travel or a spongy feel.
Check throttle pedal travel, ensure smooth operation and full return.
Check fluid level and pedal travel.
Check for suspension wear or damage.
Check for suspension wear or damage.
Check for wear or damage.
Inspect entire vehicle for loose, damaged or missing fasteners.
Adjust for proper side and rear view.
PRE-RIDE INSPECTIONS
Inspection Procedure
Electrical
General
See
Page
74
-
-
-
-
-
38
52
38
56
65
66
63
29
64
27
60-61
38
38
38,58
38
-
37