Motor; Table Processing Diagram - Brother S-1000A Basic Operation Manual

1-1. Table processing diagram

・ The top of the table should be 40 mm in thickness and should be strong enough to hold the weight and with-stand the
vibration of the sewing machine.
Drill holes as indicated in the illustration below.
・

1-2. Motor

All cords should be secured at least 25 mm away from any moving parts. Furthermore, do not excessively bend the
cords or secure them too firmly with staples, otherwise there is the danger that fire or electric shocks could occur.
Install the correct belt cover which corresponds to the motor being used.
< Motor >
・ Use one of the clutch motors given in the table at right as the motor.
・ Refer to the instruction manual for the motor for details on installing and
using the motor.
< Motor pulley and V-belt >
Select the correct motor pulley and V-belt by referring to the table below to suit the power frequency of your area.
Sewing speed
(Outer diameter)
3,500 sti/min
4,000 sti/min
Ground wire hole
Motor mounting holes
50Hz
Motor pulley
90
100
CAUTION
V-belt
43
43
S-1000A
1. INSTALLATION
Head rest hole
Cotton stand hole
Power
Single-phase 2-pole, 400 W motor
Three-phase 2-pole, 400 W motor
60Hz
Motor pulley
(Outer diameter)
75
85
3828M
Motor
V-belt
42
43
2