Bosch Dinion IP 8000 MP NBN-80052 Installation Manual page 35

DINION IP 8000 MP
Malfunction
The unit does
not report an
alarm.
Control of
cameras or other
units is not
possible.
The unit is not
operational after
a firmware
upload.
Bosch Security Systems
Possible causes
The audio voice
connection is already
in use by another
receiver.
Alarm source is not
selected.
No alarm response
specified.
The cable connection
between the serial
interface and the
connected unit is not
correct.
The interface
parameters do not
match those of the
other unit connected.
Power failure during
programming by
firmware file.
Troubleshooting | en
Solution
Wait until the
connection is free
and then call the
sender again.
Select possible alarm
sources on the Alarm
sources configuration
page.
Specify the desired
alarm response on
the Alarm
connections
configuration page; if
necessary change the
IP address.
Check all cable
connections and
ensure all plugs are
properly fitted.
Make sure that the
settings of all units
involved are
compatible.
Have the unit
checked by Customer
Service and replace if
necessary.
2014.09 | v1.0 | AM18-Q0665
35