Sony STR-DA3300ES Operating Instructions Manual page 48

Message list after auto calibration
Display
Code 30
Code 31
Code 32
Code 33
Warning 40
Warning 41
Warning 42
Warning 43
Explanation
Headphones are connected. Remove the headphones and perform the auto calibration again.
SPEAKERS (OFF/A/B/A+B) is set to OFF. Set it to others and re-perform the measurement.
None of the speakers were detected. Make sure that the optimizer microphone is connected
properly and reperform the measurement.
If the optimizer microphone is connected properly but the error code appears, the optimizer
microphone cable may be damaged or improperly connected.
• None of the front speakers are connected or only one front speaker is connected.
• The optimizer microphone is not connected.
• Either the left or right surround speakers is not connected.
• Surround back speakers are connected even though surround speakers are not connected.
Connect the surround speaker(s) to the SURROUND terminals.
• The surround back speaker is connected only to the SUR BACK SPEAKERS R terminals.
When you connect only one surround back speaker, connect it to the SUR BACK
SPEAKERS L terminals.
The measurement has completed. However, the noise level is high. You may be able to
perform the measurement properly if you try it again, even though the measurement cannot
be performed in all environments. Try to perform the measurement in a quiet environment.
The sound input from the optimizer microphone is outside the acceptable range. It is louder
than the loudest sound that can be measured. Try to perform the measurement when the
environment is quiet enough to allow proper measurement.
The volume of the receiver is out of the acceptable range. Try to perform the measurement
when the environment is quiet enough to allow proper measurement.
The distance and position of a sub woofer cannot be detected. Or the angle of the speaker
position cannot be detected. This may be caused by noise. Try to perform the measurement
in a quiet environment.
NO WARNING There is no warning information.
No speakers are connected.
-CODE 31
1
Press
8,
then follow the instructions from step
I of "Performing auto calibration."
-CODE 32, 33
1
When you press
8),
"Retry?" appears.
2
Press
+/+
to select "Yes," then press
8).
3
Follow the instructions from step 2 of
"Performing auto calibration."
48
GB
When you select "WRN CHECK"
If a warning on the measurement result is
present, detailed information is displayed.
Press
c:B
to retu rn to step 1 of
"Confirming/saving the measurement
results" (page 46).
Tip
Depending on the position of the sub woofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.