Download Print this page

Husqvarna 22" Multi-Cut Owner's Manual page 22

Rotary lawn mower 725 series briggs & stratton engine, all wheel drive, self-propelled
Hide thumbs

Advertisement

ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Husqvarna
or other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due
to suspected
carburetor problems, take
your lawn mower to a Husqvarna
or other
qualified service center for repair and/or
adjustment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact a Husqvarna
or other
qualified service center, which has proper
equipment
and experience
to make any
necessary adjustments.
Immediately
prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN
MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2.
Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened.
Inspect
moving parts for damage, breakage
and wear.
Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
IMPORTANT:
When folding the handle
for storage or transportation,
be sure to
fold the handle as shown or you may dam-
age the control cables.
Operator
MOWING
POSITION
control bar
///
/
/
iii
I
1/11
\
FOLD
, ,,
ii
i I
FORWARE
Upper
FOR
handle
STORAGE
Lower handle
HANDLE
You can fold your lawn mower handle for
storage.
1. Loosen the two "star" handle knobs on
sides of the upper handle and allow
handle to fold down to the rear.
2.
Loosen the two "standard" handle
knobs on sides of the lower handle and
pivot entire handle assembly forward
and allow it to rest on mower.
3. Reinstall "standard"
knobs and car-
riage bolts to lower handle or handle
brackets for safe keeping.
• When setting up your handle from the
storage position, you must manually
lock lower handle into mowing position.
\\
)
/
Bolt
Lower handle
"standard" knob
Handle
bracket
22

Advertisement

loading

  Related Manuals for Husqvarna 22" Multi-Cut