Starter Clutch Inspection - KYMCO Bet & Win 125 User Manual

18
. STARTING SYSTEM
ASSEMBLY
Apply grease to the dust seal in the front
cover.
Install the brushes onto the brush holders.
Apply a thin coat of grease to the two ends
of the armature shaft.
Insert the commutator into the front cover.
Install a new O-ring to the front cover.
Install the starter motor case, aligning the tab
on the motor case with the groove on the
front cover.
Tighten the starter motor case screws.
INSTALLATION
Connect the starter motor cable.
Check the O-ring for wear or damage and
replace if necessary.
Apply grease to the O-ring and install it to
the starter motor.
Tighten the two mounting bolts.

STARTER CLUTCH INSPECTION

Refer to pages 10-4 and 10-5 for the starter
clutch removal, inspection and installation.
18-5
Bet & Win 125/150
Front Cover
Tab
Groove
Motor Case
O-ring
Starter Motor Cable
O-ring