Error Code List - Casio TE-2200 Service Manual

6. ERROR CODE LIST

Error
Message
code
E001 Wrong mode
E003 Wrong operator
E004 Error INIT/FC
E005 Insufficient memory
E008 Please sign on
E009 Enter password
E010 Close the drawer
E011 Close the drawer
E016 Change back to REG
mode
E017 Enter CHK/TBL
number
E018 Enter Table number
E019 Enter number of
customers
E021 No DEPT Link
E023 Stock shortage
E024 No stock
E026 Enter condiment/
preparation PLU
E029 In the tender
operation
E030 Press RATE TAX
key
E031 Press ST key
E032 Press FSST key
E033 Enter tendered
amount
E035 Change amount
exceeds limit
E036 Remove money from
the drawer
E037 Digit or amount
limitation over
E038 Perform money
declaration
E040 Issue guest receipt
E041 Print validation
E042 Insert VLD paper
and retry
Meaning
Mode switch position changed before finalization.
Clerk button pressed before finalization of a
registration being performed under another clerk
button.
The signed on clerk differs from the clerk
performed the tracking check registration.
Initialization or unit lock clear operation in
progress.
Memory allocation exceeds total memory
capacity.
Registration without entering a clerk number.
Operation without entering the password.
The drawer is left open longer than the program
time (drawer open alarm).
Attempt to register while the cash drawer is open.
Two consecutive transactions attempted in the
refund mode.
Attempt made to register an item without inputting
a check number.
Attempt made to register an item without inputting
a table number.
Finalize operation attempted without entering
the number of customer.
No department linked PLU is registered.
Actual stock quantity becomes less than the
minimum stock quantity.
Actual stock quantity becomes/is negative.
No condiment/preparation PLU is registered.
Item registration is prohibited, while partial tender.
Finalization of a transaction attempted without
registering rate-tax.
Finalization of a transaction attempted without
confirming the subtotal.
Finalization of a transaction attempted without
confirming of the food stamp subtotal.
Finalize operation attempted without entering
amount tender.
Change amount exceeds preset limit.
Contents of the drawer exceed programmed
limit.
High amount lock out/low digit lock out error
Read/reset operation without declaring cash in
drawer.
This error appears only when this function is
activated.
Attempt to register a new transaction without
issuing a guest receipt.
Attempt to register a new transaction without
validation.
Validation paper (slip printer) has run out.
Return the mode switch to its original setting and
finalize the operation.
Press the original clerk button and finalize the
transaction before pressing another clerk button.
Input correct check number or assign the proper
clerk number.
Complete operation.
Reallocate memory or expand memory (if
possible).
Enter a clerk number.
Enter password.
Close the drawer.
Shut the cash drawer.
Switch to another mode and then back to the RF
mode for the next transaction.
Input a check number.
Input a table number.
Enter the number of customer.
Correct the program.
Perform stock maintenance.
Perform stock maintenance.
Register condiment/preparation PLU.
Finalize the transaction.
Register <RATE TAX>.
Press <SUBTOTAL>.
Press <FS/ST>.
Enter the amount tendered.
Input amount tendered again.
Perform pick up operation.
Enter correct amount.
Perform money declaration.
Issue a guest receipt.
Perform validation operation.
Insert new validation paper.
— 55 —
Action