Philips DVP6600 Service Manual page 22

Remote reception is insensitive or fails.
Remote reception is
insensitive or fails.
Check if the remote
control works properly.
Check if the power supply
voltage to the remote censor
is normal are normal.
Use an oscilloscope to check if there is
output waveform from the first pin IR of the
remote censor after pressing button on the
remote control.
Check if there is IR
signal on pin 109 of U4
Go
Yes
Yes
Yes
No
Correct connection
4-9
No
Check battery
No
Check R315 CE301
No
REM301 (PIN 3 - RC waveform)
Yes
Change U4
IR waveform
Trouble shooting chart