Dolby Digital And Dts; Muting The Sound; Adjusting The Subwoofer Level; Speaker Level Adjustments - Panasonic SC-RT30 Operating Instructions Manual

SFC/EQ
CH
DVD
Numbered
buttons
, , , 
ENTER
B
A
SFC/EQ
MIX 2CH
CH SELECT

Dolby Digital and DTS

≥Dolby Digital and DTS are digital encoding systems used on DVD
to carry surround sound. Both were originally developed for use in
cinemas.
≥This unit automatically recognizes and decodes these systems.
Software encoded with Dolby
Digital can be identified with
this mark.
Play a Dolby Digital or DTS source.
The Dolby Digital or DTS indicator lights.
∫ To down-mix Dolby Digital or DTS (multiple-
channel) signals to 2 channels
Press [MIX 2CH].
≥To cancel
Press [MIX 2CH] again.
When "D.MIX" flashes on the display
[DVD-A]
The DVD-Audio contains multiple-channel
signals that cannot be down-mixed.
OPEN/CLOSE
FUNCTIONS
C
H.BASS
MUTING
SW.LEVEL
Software encoded with DTS can
be identified with this mark.

Muting the sound

Press [MUTING].
"MUTING" flashes on the unit's
display.
To cancel
≥Press [MUTING] again or reduce the volume to minimum "VOL 0",
then raise it to the required level.
≥Muting is cancelled when you switch the unit to standby.
∫ To listen to sound from this unit through your
television's speakers
Connect the television and the AV1 terminal on the main unit using a
21-pin Scart cable.
Press and hold [MUTING] until "A1 MUTE OFF" appears on the
unit's display.
The audio is output from both the speakers and the television.
To mute sound from this unit's speakers (➡above)
≥To cancel, press and hold [MUTING] and select "A1 MUTE ON".

Adjusting the subwoofer level

Press [SW.LEVEL].
Each time you press the button:
SUB WOOFER 1>SUB WOOFER 2>SUB WOOFER 3
^------------SUB WOOFER 4 (factory preset),-----------}
≥The setting you make is retained.
≥This cannot be set when headphones are connected.

Speaker level adjustments

Adjust the level of the speakers so they are the same apparent level
as the front speakers where you would normally be sitting and
listening.
Preparation
≥Press [DVD] to select the DVD drive.
≥Turn off the other sound effects.
When stopped or playing discs with 2 channel or
monaural audio
You can adjust the balance of the front speakers.
≥You can also adjust the L/R Surround speakers while "Sound Field
Control (SFC)" is set to on. Please perform the following "When
playing Multi-channel discs" operations.
1 Press [CH SELECT].
L R
2 Press [2, 1] to adjust the "L", "R" balance.
When playing Multi-channel discs
1 Press [CH SELECT].
L R
2
While the screen above is being displayed
Press [CH SELECT] to select the speaker.
L, R>Cch>RSch>LSch>SWch
^---------------------------------------------------}
SW: Subwoofer
≥You can only adjust SW if there is output from the subwoofer
channel.
3 Press [3] (to increase) or [4] (to decrease).
Press [2, 1] to adjust the "L", "R" balance.
L, R:
C, RS, LS: j6 dB to i6 dB
j6 dB to i6 dB
SW:
RQT8728
35