Charger Control Identification; Power Source - GRAUPNER ULTRAMAT AC/DC EQ Operating Instructions Manual

◎ CHARGER CONTROL IDENTIFICATION

AC Input
+ Output
- Output

◎ POWER SOURCE

1. Connect charger to 12V DC power supply or AC110-220V
2. Connect the charger's red alligator clip to the positive (+) terminal on the power source
and the black alligator clip to the negative (-) terminal. In case of DV 12V input, charg-
er will display "INPUT BATTERY VLOTAGE ERROR" message if the input is below
11V or above 15V. In this case, please recheck the input power supply to make sure
adequate power is present.
If AC power is being used as input power, do NOT try to connect the 12V DC power!
6
ULTRAMAT AC/DC EQ
Balancing port
2-line, 16 character LCD
Balancer port
+ Output
AC lnput
- Output
Buttons