Operating Other Components - Sony RM-PP404 Operating Instructions Manual

Brief descriptions of buttons used for
advanced remote operations
Program indicator: Lights up during programming
operations.
?/1, AV ?/1, MASTER VOLUME – : Press these buttons
at the same time to reset all the function buttons to the
factory settings and to clear the programmed signals set
for operation of non-Sony components.
Numeric buttons: Use when changing the factory
settings of the function buttons or specifying the maker of
the component that you want to control using the remote.
ENTER D.TUNING: Use when changing the factory
settings of the function buttons or setting the remote to
operate non-Sony components.
Function buttons: Come with factory settings that can be
changed to suit the components you have.
IR SET: Press to set the remote to operate non-Sony
components.
12 GB
Operating Other
Components
You can program the remote to control other components
or non-Sony components by changing the code. Once the
control signals have been memorized, you can use those
components as part of your system.
Furthermore, you can also program this remote for Sony
components that the remote is unable to control. Note
that the remote can control the components that accept
infrared wireless control signals only.
Notes
• The settings of PHONO and TUNER cannot be changed.
• When you assign a component to the TV CONTROL button,
you can operate the programmed component without changing
the function of the receiver.
1
Press IR SET.
The program indicator lights up.
2
Press the function button for the component you
want to control.
For example, if you are going to control a CD player,
press CD.
3
Press the numeric buttons to enter the numeric
code (or one of the codes if more than one code
exist) corresponding to the component and the
make of the component you want to control.
See the tables on pages 14 and 15 for information on
the numeric code(s) corresponding to the component
and the maker of the component (the first digit and
the last two digits of the numeric code(s) correspond
to the category and the maker's code respectively).
4
Press ENTER D.TUNING.
When the program indicator flashes twice, the
component(s) can then be controlled using this
remote.
5
Repeat Steps 1 to 4 to control other components.